Simulation crash "Command terminated by signal 6"
Posted: Mon Feb 23, 2009 8:26 am
Hello,
I set up some test simulations based on minimized sequences as input files, but the simulations crashed really early with the following error:
"Command terminated by signal 6"
"Command terminated by signal 25"
What does it mean ?
What I found out is, that there is a higher crashing rate for the simulation proportional to the length and complexity of the sequence I use. E.g the simulations with 3 AA run perfect, but if I take the same 3 AA and make a random chain of 41 AA out of it, the system crashes (command terminated by signal 6).
I hope you can help me to solve this problem.
I set up some test simulations based on minimized sequences as input files, but the simulations crashed really early with the following error:
"Command terminated by signal 6"
"Command terminated by signal 25"
What does it mean ?
What I found out is, that there is a higher crashing rate for the simulation proportional to the length and complexity of the sequence I use. E.g the simulations with 3 AA run perfect, but if I take the same 3 AA and make a random chain of 41 AA out of it, the system crashes (command terminated by signal 6).
I hope you can help me to solve this problem.